Trying to record "Power On" command from Panasonic TV remote, which works by keeping the Power button pressed for a couple of seconds. But iLearn will only capture the first part of the command, not the entire duration of key press. Any solutions?
Date
Votes
6 comments
-
Josh Sherman The solution you are looking for resides in the top right part of the iLearn application. By changing the Gaps setting (initially set to 1), the amount of highlighted information changes. As you change the amount of highlighted information in the center window, the amount of information saved by iLearn will lengthen. Just capture the same amount of data that you need to send (by holding the button down while learning), and make sure to highlight the majority, if not all, of the information so that you can get a good code length for your hardware. Let me know if you have any problems getting this to work.
-
Hardwarereg The same problem with the same tv! Does somebody have a working code?
-
Josh Sherman If the TV does not respond to the code, then either the code is not the entirety of the IR data, or the IR code is not getting to the device's IR receiver. If you test with the IR blaster of your unit, that will assure that the code is strong enough to get to the receiver. If your problem continues after that, then the code is likely at fault. Does this code work when sent from the Pronto?
-
Hardwarereg Yes. Pronto works fine.
-
Hardwarereg The Pronto uses 1sec duration to send the code! How can I change the duration for GC? Thx.
Please sign in to leave a comment.