I'm trying to use the GC-SP1 AC / DC Voltage Sensor to monitor the status of a WDTV Live Hub.
I believe the hadrware is working perfectly. The sensor is connected to port 1:2 and when the WDTV is turned on, the LED on the back of iTach (connector = 1:2) is lit and when the WDTV is turned off the LED is off.
Using iTest for sending commands, the result was this:
literal response = state,1:2,0
Hex code and ASCII response = 0x73 0x74 0x61 0x74 0x65 0x2C 0x31 0x3A 0x32 0x2C 0x30 0x0D
literal response = state,1:2,1
Hex code and ASCII response = 0x73 0x74 0x61 0x74 0x65 0x2C 0x31 0x3A 0x32 0x2C 0x31 0x0D
This is the config of my iTach WF2IR
Conector 1 = IR Out
Conector 2 = Sensor Notify, Notify Port = 9132, Notify Timer = 10 (sec)
Conector 3 = IR Blaster
How to set up a project in CommandFusion?
I created the same topic in Command Fusion forum but got no solution.