i was using my GC-100 (sending test commands via com), and then plugged in an IR-sensor. Suddenly the GC-100 was not reachable anymore via ethernet. i resetted to defaults, and iHelp discovered the device on the network with its default 192.168... IP, yet i am unable to configure it (yes, i changed the ip of my PC to the correct subnet). I resetted again to defaults and now i cant reach the device on any ip, and iHelp wont discover it either.
The "link" led is dead and the "act" led is constantly on, is that correct? Is my device dead, has anyone suggestions of what i could do?